Inspection |
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the temperature control actuator connector.
|
3. |
Verify that the temperature control actuator operates to the warm position
when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the temperature control actuator operates to the cool position
when connected in reverse.
|
4. |
Connect the temperature control actuator connector.
|
5. |
Turn the ignition switch ON.
|
6. |
Check the voltage between terminal 4 and 5.
Specification
It will feedback the current position of the actuator to the controls.
|
7. |
If the measured voltage is not specification, substitute with a known-good
temperature control actuator and check for proper operation.
|
8. |
If the problem is corrected, replace the temperature control actuator.
|
Replacement |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
|
3. |
Remove the driver side shower duct (A) after loosening the screw.
|
4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the heater & blower assembly.
(Refer to Heater - "Heater Unit")
|
3. |
Separate the blower unit from the heater unit after loosening 3 screws.
|
4. |
Disconnect the connector (A) and then remove the temperature control
actuator (B) after loosening the mounting screws.
|
5. |
Install in the reverse order of removal.
|
Kia Cee'd JD Service Manual: Specifications
Specifications
Item
Specification
Master cylinder
Cylinder I.D.
22.22 mm
Piston stroke
45 ± 1 mm (1.77 ± 0.039 in)
Fluid level switch
Provided
...
Kia Cee'd JD Service Manual: Description and operation
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of On Board Diagnostics
(OBD) for vehicles sold in California beginning with the 1988 model year. The
first phase, OBD-I, required monitoring of the fuel metering system, Exhaust
Gas Rec ...