Warning Lamp Activation |
Warning Lamp Behavior after Ignition On |
1. |
Active fault or historical fault counter is greater or equal to 10.
|
2. |
Normal or historical fault counter is less than 10.
|
3. |
When turning the ignition switch ON during variant coding (EOL) mode,
the airbag warning lamp is turned on and blinks at intervals of 1 second
till the coding is completed.
In case the variant coding is normally completed, the airbag warning
lamp is turned on for 6 seconds, and then turned off. Otherwise the
airbag warning lamp continuously blinks at intervals of 1 second.
When there is active fault in airbag system or SRSCM internal fault,
the variant coding (EOL) can’t be completed. In this case, do the variant
coding (EOL) procedure again after troubleshooting with the GDS.
|
1. |
Loss of battery supply to the SRSCM : warning lamp turned on continuously.
|
2. |
Loss of internal operating voltage : warning lamp turned on continuously.
|
3. |
Loss of Microprocessor operation : warning lamp turned on continuously.
|
4. |
SRSCM not connected : warning lamp turned on continuously.
|
Kia Cee'd JD Service Manual: Parking Brake Lever Repair procedures
Removal
The parking brake cables must not be bent or distorted. This will lead
to stiff operation and premature failure.
1.
Remove the floor console assembly.
(Refer t ...
Kia Cee'd JD Owners Manual: Dual clutch transmission operation
The dual clutch transmission has 7 (or 6)
forward speeds and one reverse speed.
The individual speeds are selected automatically
in the D (Drive) position.
WARNING
To reduce the risk of serious injury
or death:
ALWAYS check the surrounding
areas near your vehicle for people,
es ...