Ford Escape: Charging Your Vehicle - Plug- In Hybrid Electric Vehicle (PHEV) / Setting the Charging Schedule and Preferences

Ford Escape. Setting the Charging Schedule and Preferences

Note: Select charge settings on the home page of the touchscreen or under the vehicle settings menu to access charge preferences.

Charging may not begin upon plugging in if you have set up preferred charge times for this vehicle location. Your vehicle could delay charging to take advantage of off-peak electricity rates. Your vehicle optimizes the charge schedule to be complete by your next departure time.

When waiting to charge, plugged in and not currently charging, the charge status indicator shows the present state of charge of the high voltage battery by lighting up all completed zones for 30 seconds before turning off. For example, if the battery is at 70 percent charge then the bottom three zones solidly light up to indicate a battery charge level of at least 60 percent but less than 80 percent. When the current state of charge is less than 20 percent, none of the zones light up.

Note: When your vehicle is waiting to charge, the charge status indicator turns off 30 seconds after displaying the present state of charge. When your vehicle begins charging, the charge status indicator turns on and displays the status of the charge, as described above.

Charge Times Button

Use the charge times button to either turn off or turn on your charge times settings for this location. Select charge settings on the home page of your touchscreen or under the vehicle settings menu to access charge preferences.

Ford Escape. Setting the Charging Schedule and Preferences

AC Charging
Connecting the Charger To charge the high-voltage battery: Put the vehicle in park (P). Press the center right edge of the charge port door and then release to open the door. Plug the chargi ...

Charging Your Vehicle – Troubleshooting
Charging Your Vehicle – Information Messages Charging Your Vehicle – Frequently Asked Questions Why does my vehicle have a hum or fan noise when charging? A hum or a fan noise could be present w ...

Other information:

Kia Cee'd JD Service Manual: Rail Pressure Sensor (RPS) Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed.   Condition Output Voltage (V) ...

Kia Cee'd JD Service Manual: Back-up Lamp Switch Repair procedures
Inspection 1. Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner") 2. Remove the battery and battery tray. (Refer to Engine Electrical System - "Battery") ...

© 2017-2021 www.kceed.com