Kia Cee'd: Seat Belt Pretensioner (BPT) / Repair procedures

Kia Cee'd JD Service Manual / Restraint / Seat Belt Pretensioner (BPT) / Repair procedures

Removal

1.	Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work.

2.	Remove the lower anchor bolt.

3.	Remove the center pillar trim. (Refer to Body - "Center pillar trim")

4.	Remove the upper anchor bolt.

5.	Disconnect the seat belt pretensioner connector (A).

6.	Loosen the seat belt pretensioner mounting bolts (B,C) and remove the seat belt pretensioner.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Install the seat belt pretensioner with a bolts (B, C).

Tightening torque

Bolt B: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

4.	Connect the seat belt pretensioner (BPT) connector (A).

Install the upper anchor bolts.

Tightening torque

: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

6.	Install the center pillar trim. (Refer to Body - "Center pillar trim")

Install the lower anchor bolts.

Tightening torque

: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)

8.	Reconnect the battery negative cable.

After installing the seat belt pretensioner, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Components and components location

Components ...

Brake System

...

Other information:

: Trailer Sway Control
How Does Trailer Sway Control Work The system applies the brakes to the individual wheels and reduces engine torque to aid vehicle stability. If the trailer begins to sway, the stability control lamp flashes and the message Trailer Sway Reduce Speed appears in the information display. Stop your ...

Kia Cee'd JD Owners Manual: Front fog light
Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc. The fog lights will turn on when the fog light switch (1) is turned on after the position light is turned on. To turn off the fog lights, turn the fog light switch (1) to the O (Off ...