Kia Cee'd: Rear Door / Rear Door Module Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Repair procedures

Replacement

1.	Remove the rear door window glass. (Refer to Rear Door - "Rear Door Window Glass")

2.	Remove the rear door outside handle. (Refer to Rear Door - "Rear Door Outside Handle")

Loosen the rear door channel mounting bolt and nuts.

Tightening torque :

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.	Remove the rear door channel (A).

5.	Loosen the outside handle base mounting bolt (A).

6.	Loosen the rear door latch (B) mounting screws.

After loosening the mounting bolts, then remove the rear door module (A).

Tightening torque :

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

8.	Disconnect the rear door module mounting clip (B).

9.	Disconnect the connectors and rear door module wiring harness (A).

10.

Install in the reverse order of removal.

•	The area of whole parts should be applied with sufficient grease.

•	Make sure connectors are connected properly and each rod is connected securely.

•	Make sure the door locks/unlocks and opens/closes properly

Rear Door Module Components and components location

Component Location 1. Rear door module ...

Rear Door Outside Handle Components and components location

Component Location 1. Rear door outside handle ...

Other information:

Kia Cee'd JD Owners Manual: Icy road warning light
This warning light is to warn the driver the road may be icy when: Ignition ON Temperature range: approximately below 4°C (39.2°F). The warning light will blink for 10 seconds and then illuminate. Also, the warning chime will sound. ✽ NOTICE If the icy road warning light ap ...

Kia Cee'd JD Service Manual: Rear Door Inside Handle Repair procedures
Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. After loosening the mounting screws, then remove the rear door inside handle (A). 3. Ins ...