Kia Cee'd: Front Bumper / Radiator Grill Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Bumper / Radiator Grill Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover")

2.	Loosen the radiator grill upper cover mounting clips.

3.	Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill upper cover (A).

4.	Disconnect the front bumper energy absorber mounting wiring harness (C).

5.	Detach the clips (B), then remove the front bumper energy absorber (A).

6.	Remove the radiator grill mounting rivet and then loosen the screws.

7.	Unlock the lock pins (B) by pushing it up with a screwdriver or remover and then remove the radiator grill (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

Radiator Grill Components and components location

Component Location 1. Radiator grill ...

Rear Bumper

...

Other information:

Kia Cee'd JD Service Manual: Specifications
Specification Engine T/M Joint type Max . permissible angle Outer Inner Outer Inner Gamma 1.4 MPI 6 M/T BJ#22 TJi#22 ...

Kia Cee'd JD Service Manual: Power Seat Control Switch Repair procedures
Inspection 1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control switch B : Lumbar support swi ...