Ford Escape: Garage Door Opener / Programming the Garage Door Opener to Your Gate Opener Motor

Ford Escape 2020-2021 Owners Manual / Garage Door Opener / Programming the Garage Door Opener to Your Gate Opener Motor

Gate Operator / Canadian Programming

Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators “time-out” in the same manner.

Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the “cycling” process to prevent possible overheating.

  1. Press and release, every two seconds, your hand-held transmitter until the HomeLink indicator light changes to a rapidly blinking or continuously on light.
  2. Release the hand-held transmitter button.
  3. Press and hold the HomeLink function button you want to program for two seconds, then release. You may need to do this twice to activate the door.

    Note: If the indicator light stays on, the programming is complete.

    Note: If the HomeLink indicator flashes rapidly, repeat Step 3.

    Note: If your device still does not operate, you must program your garage door.

  4. To program additional buttons, repeat Steps 1 – 4.
Programming the Garage Door Opener to Your Garage Door Opener Motor
Press the learn button on the garage door opener motor, you have 30 seconds to complete the next two steps. Return to your vehicle. Press and hold one of the three HomeLink function buttons ...

Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies
Clearing the Garage Door Opener Press and hold the outer two function buttons simultaneously for approximately 10 seconds until the indicator light above the buttons flashes rapidly. When ...

Other information:

Kia Cee'd JD Service Manual: ESP Control Module Repair procedures
Removal [LHD] 1. Turn the ignition switch OFF. 2. Pull up the lock of the HECU connector (A) , then disconnect the connector. 3. Remove the brake fluid from the master cylinder reservoir with a ...

Kia Cee'd JD Service Manual: Timing Chain Repair procedures
Removal 1. Turn the crankshaft pulley clockwise, and align its groove with the timing mark of the timing chain cover. 2. Remove the timing chain cover. (Refer to Timing System - "Timing Chain Cover") ...

© 2017-2021 www.kceed.com