Kia Cee'd: Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Kia Cee'd JD Service Manual / Restraint / Airbag Module / Passenger Airbag (PAB) Module Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.

2.	Remove the glove box housing. (Refer to Body - "Glove box housing")

3.	Disconnect the passenger airbag connector (A) and remove the PAB mounting bolts (B).

Remove the crash pad.

(Refer to Body - "Main crash pad assembly")

Replace the crash pad which is damaged while PAB is deployed.

Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable from battery and wait for at least thirty seconds before beginning work.

Place a passenger airbag on the crash pad and tighten the passenger airbag mounting bolts.

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.	Install the crash pad. (Refer to Body - "Main crash pad assembly")

Tighten the passenger airbag mounting bolts.

Tightening torque :

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

6.	Connect the passenger airbag harness connector to the SRS main harness connector.

7.	Reinstall the glove box housing. (Refer to Body - "Glove box housing")

8.	Reconnect the battery negative cable.

After installing the passenger airbag (PAB), confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Passenger Airbag (PAB) Module Components and components location

Components ...

Side Airbag (SAB) Module Description and operation

Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment o ...

Other information:

Kia Cee'd JD Owners Manual: 5. Steering wheel control
The above message will appear if the shift lever is in R (Reverse). The steering wheel will be controlled automatically. The system will be cancelled if you firmly hold the steering wheel while it is controlled automatically. The system will be cancelled if vehicle speed is o ...

Kia Cee'd JD Service Manual: Repair procedures
Inspection 1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. Removal 1. Drain the brake fluid through the bleed plug (A). ...