| Removal |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
| 3. |
Disconnect the connector (A) from the front bumper.
|
| 4. |
Pull out the sensor (B) by opening the sensor holder (C) out.
|
| Installation |
| 1. |
Install the ultra sensor after connecting the connector.
|
| 2. |
Install the bumper.
|
Parking Assist Sensor Components and components location
Rear Parking Assist System Switch Repair proceduresKia Cee'd JD Owners Manual: Headlamp delay function
The headlamps (and/or taillights) remain
on for same minutes (Type A: 20 minutes,
Type B: 5 minutes) after the ignition key
is removed or turned to the ACC or
LOCK position. However, if the driver’s
door is opened and closed, the headlights
are turned off after 15 seconds.
The headli ...
Kia Cee'd JD Owners Manual: To install the barrier net
1. Open the cover (if equipped) for the
holder position (1) or (2) you want to
install.
2. Compress the one side net upper shaft
to length direction before insert the net
upper shaft into the large hole (3) and
then secure by sliding into the small
hole (4).
3. Hang the net strap ...