Kia Cee'd: Front Seat / Front Seat Assembly Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Assembly Repair procedures

Replacement
1.
Remove the front seat track mounting cover (A).
2.
After loosening the mounting bolts, remove the front seat assembly (B).
Tightening torque :
34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)

3.
Disconnect the airbag connector (A), power seat & seat warmer connector connector (B), seat belt buckle connector (C), seat belt remind connector (D).
[Driver's]

[Passenger's]

4.
Install in the reverse order of removal.
  
•
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.
Front Seat Assembly Components and components location
Component Location   1. Front seat assembly ...

Front Seat Shield Outer Cover Components and components location
Component Location   1. Front seat shield outer cover ...

Other information:

Kia Cee'd JD Service Manual: Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negative cable from the battery. ...

Kia Cee'd JD Owners Manual: Mechanical key
If the transmitter or smart key does not operate normally, you can lock or unlock the doors by the mechanical key. Insert the key into the key hole of the outside door handle.Turn the key toward the rear of the vehicle to unlock and toward the front of the vehicle to lock. I ...

© 2017-2026 www.kceed.com