Kia Cee'd: Front Suspension System / Front Lower Arm Repair procedures

Kia Cee'd JD Service Manual / Suspension System / Front Suspension System / Front Lower Arm Repair procedures

Replacement

1.	Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported.

Remove the front wheel and tire (A) from front hub.

Tightening torque:

88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)

•	Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

Remove the lower arm (A) from the knuckle.

Tightening torque:

98.0~117.6 N.m(10.0~12.0 kgf.m, 72.3~86.7 lb-ft)

Loosen the bolts and nuts and then remove the front lower arm (A).

Tightening torque

98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)

Tightening torque

156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)

5.	Install in the reverse order of removal.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the front stabilizer bar for deformation.

3.	Check the all bolts and nuts.

Front Strut Assembly Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front w ...

Front Stabilizer Bar Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front w ...

Other information:

Kia Cee'd JD Service Manual: Blind Spot Detection Switch Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad Lower Panel") 3. Remove the lower crash pad switch assembly (A) ...

: Driving Through Shallow Water
WARNING: Do not attempt to cross a deep or flowing body of water. Failure to follow this instruction could result in the loss of control of your vehicle, personal injury or death. Note: Driving through standing water can cause vehicle damage. Note: Engine damage can occur if water enters the a ...