Kia Cee'd: Front Door / Front Door Trim Repair procedures

Replacement
  
•
Put on gloves to protect your hands.
  
•
Be careful not to scratch the door trim and other parts.
1.
Using a screwdriver or remover, remove the front door grip handle cover (A).

2.
Using a screwdriver or remover, remove the front door inside handle housing (A) and front door pull handle cap (B).

3.
After loosening the mounting screws, then remove the front door trim (A).

4.
Disconnect the front door inside handle cable (A).

5.
Disconnect the IMS switch connector (A) and power window switch connector (B).

6.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
Front Door Trim Components and components location
Component Location   1. Front door trim ...

Front Door Inside Handle Repair procedures
Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. After loosening the mounting ...

Other information:

Kia Cee'd JD Owners Manual: Non-operating condition
The sensors are located inside of the rear bumper. Always keep the rear bumper clean for the system to work properly. WARNING The warning light on the outside rearview mirror will illuminate whenever a vehicle is detected at the rear side by the system. To avoid accidents, do ...

Kia Cee'd JD Service Manual: Description and operation
Description Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the deicer switch, then controls relay. Operating cond ...

© 2017-2026 www.kceed.com