Kia Cee'd: Front Door / Front Door Latch Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Door / Front Door Latch Repair procedures

Replacement

1.	Remove the front door module. (Refer to Front Door - "Front Door Module")

2.	Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

3.	Disconnect the front door outside handle cable (A).

4.	Disconnect the front door latch connector (B).

5.	Remove the front door latch assembly (A) by pulling it.

6.	Remove the front door inside handle cable (A) by pulling it.

Install in the reverse order of removal.

•	Make sure the connector is connected properly.

•	Make sure the door locks/unlocks and opens/closes properly.

•	Replace any damaged clips.

Front Door Latch Components and components location

Component Location 1. Front door latch ...

Front Door Belt Inside Weatherstrip Repair procedures

Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt in ...

Other information:

: Programming the Garage Door Opener to Your Gate Opener Motor
Gate Operator / Canadian Programming Canadian radio-frequency laws require transmitter signals to “time-out” (or quit) after several seconds of transmission – which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate ...

: Auto Hold
How Does Auto Hold Work Auto Hold applies the brakes to hold your vehicle after you stop it and release the brake pedal. This can help when waiting on a hill or in traffic. Switching Auto Hold On and Off WARNING: The system does not replace the parking brake. When you leave your vehicle, always ...