Kia Cee'd: Front Bumper / Front Bumper Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Pull out the head lamp washer nozzle outward.

2.	Then remove the head lamp washer nozzle cover (A) by widening both lock pins (B) outward using two gimlets.

3.	Loosen the radiator upper cover (A) mounting clips.

4.	Loosen the front bumper lower mounting clips.

5.	After loosening the front bumper side's mounting screw, then disconnect the side's.

6.	Disconnect the fog lamp connector (A) and front parking assist sensor connector (B). [LH] [RH]

7.	Remove the front bumper cover (A).

Install in the reverse order of removal.

•	Replace any damaged clips.

•	Make sure the connector is plugged in properly.

Front Bumper Cover Components and components location

Component Location 1. Front bumper cover ...

Radiator Grill Components and components location

Component Location 1. Radiator grill ...

Other information:

Kia Cee'd JD Service Manual: Brake Booster Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully the first time but gradually becomes higher when ...

Kia Cee'd JD Service Manual: Antenna Repair procedures
Removal 1. Remove the rear roof trim. (Refer to Body - "Roof Trim Assembly") 2. Disconnect the roof antenna connectors (A). 3. Remove the roof antenna (B) after loosening a nut ( ...