Kia Cee'd: Interior Trim / Door Scuff Trim Repair procedures

Replacement
[5Door]
  
Put on gloves to protect your hands.
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]

2.
Pull out the rear seat cushion (A).

3.
After loosening the mounting screws, then remove the rear door scuff trim (A).
[Rear]

4.
Install in the reverse order of removal.
  
Make sure the connector are connected in properly.
Replace any damaged clips.
[3Door]
  
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.
1.
Using a screwdriver or remover, remove the front door scuff tirm (A).
[Front]

2.
Install in the reverse order of removal.
  
Replace any damaged clips.
Door Scuff Trim Components and components location
Component Location [5Door]   1. Front door scuff trim 2. Rear door scuff trim [3Door]   1. Front door ...

Cowl Side Trim Components and components location
Component Location   1. Cowl side trim ...

Other information:

Kia Cee'd JD Service Manual: Variable Intake Solenoid(VIS) Actuator Repair procedures
Removal and Installation 1. Disconnect the battery nagative terminal. 2. Disconnect the lever (A) and hose (B). 3. Loosen the mounting bolts and then remove the VIS actuator (C). ...

: Blind Spot Information System Requirements. Switching Blind Spot Information System On and Off
Blind Spot Information System Requirements Blind spot information system turns on when all the following occur: You start your vehicle. You shift into drive (D). The vehicle speed is greater than 6 mph (10 km/h). Switching Blind Spot Information System On and Off To switch blind spot informa ...

© 2017-2026 www.kceed.com