Kia Cee'd: Ignition System / Description and operation

Ignition timing is controlled by the electronic control ignition timing system.

The standard reference ignition timing data for the engine operating conditions are pre-pro grammed in the memory of the ECM (Engine Control Module).

The engine operating conditions (speed, load, warm-up condition, etc.) are detected by the various sensors. Based on these sensor signals and the ignition timing data, signals to interrupt the primary current are sent to the ECM.

The ignition coil is activated, and timing is controlled.

Ignition System

...

Repair procedures

On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

Other information:

Kia Cee'd JD Service Manual: Components and components location
Components (1) [5Door]   1. Front pillar trim 2. Cowl side trim [LH] 3. Cowl side trim [RH] 4. Center pillar upper trim 5. Center pillar lower trim 6. Rear wheel house trim 7. Rear pillar trim 8. Front door scuff trim 9 ...

: Clearing the Garage Door Opener. Reprogramming the Garage Door Opener. Garage Door Opener Radio Frequencies
Clearing the Garage Door Opener Press and hold the outer two function buttons simultaneously for approximately 10 seconds until the indicator light above the buttons flashes rapidly. When the indicator light flashes, release the buttons. Note: You cannot erase individual buttons. Repr ...