Kia Cee'd: Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Kia Cee'd JD Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module Repair procedures

Removal

1.	Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.

2.	Remove the roof trim assembly. (Refer to Body - "Roof trim assembly")

3.	Disconnect the curtain airbag harness connector (A).

4.	After loosening the mounting bolts remove the curtain airbag.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Tighten the curtain airbag mounting bolts.

Tightening torque

: 7.0 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

•	Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.

4.	Connect the curtain airbag connector.

5.	Install the roof trim assembly. (Refer to Body - "Roof trim assembly")

6.	Reconnect the battery negative cable.

After installing the curtain airbag (CAB), confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Curtain Airbag (CAB) Module Components and components location

Components ...

Airbag Module Disposal Description and operation

Airbag Disposal Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped ...

Other information:

Kia Cee'd JD Service Manual: Inside Rear View Mirror Components and components location
Component Location 1. Inside rear view mirror ...

Kia Cee'd JD Service Manual: Cylinder Head Repair procedures
Removal Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted surfaces. • To avoid dam ...