Kia Cee'd: Crash Pad / Crash Pad Lower Panel Repair procedures

Kia Cee'd Service Manual / Body (Interior and Exterior) / Crash Pad / Crash Pad Lower Panel Repair procedures

Replacement
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.
  
Take care not to scratch the body surface.
1.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).

2.
After loosening the mounting screws, then remove the crash pad lower panel (A).

3.
Disconnect the diagnosis connector (A) and crash pad lower switch connector (B).

4.
Install in the reverse order of removal.
  
Make sure the connector are connected in properly.
Replace any damaged clips.
Crash Pad Lower Panel Components and components location
Component Location   1. Crash pad lower panel ...

Crash Pad Lower Panel Repair procedures
Replacement    • When prying with a flat-tip screwdriver, wrap it with protective ...

Other information:

Kia Cee'd Service Manual: ETC (Electronic Throttle Control) System Description and operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input. The ECM ...

Kia Cee'd Service Manual: Tail Gate Weatherstrip Repair procedures
Replacement 1. Remove the tail gate weatherstrip (A).    • Do not apply sealant to the body. ...

© 2017-2019 www.kceed.com