Kia Cee'd: Troubleshooting / Compressor Oil Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / Compressor Oil Repair procedures

Oil Specification

1.	The R-134a or R-1234yf system requires synthetic compressor oil (PAG) whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.

2.	Compressor oil (PAG) varies according to compressor model. Be sure to use oil specified for the model of compressor.

Handling of Oil

1.	The oil should be free from moisture, dust, metal powder, etc.

2.	Do not mix with other oil.

3.	The water content in the oil increases when exposed to the air. After use, seal oil from air immediately. (R-134a or R-1234yf compressor oil absorbs moisture very easily.)

4.	The compressor oil must be stored in steel containers, not in plastic containers.

Compressor Oil Check

The oil used to lubricate the compressor is circulating with the refrigerant.

Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.

Oil total volume in system

PAG OIL (FD46XG) : 110 ± 10cc

Oil Return Operation

There is close affinity between the oil and the refrigerant.

During normal operation, part of the oil recirculation with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows :

1.	Open all the doors and the engine hood.

2.	Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position.

3.	Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system.

4.	Stop the engine.

Air Conditioning System Components and components location

Component Location Index Engine Room 1. Receiver Drier 2. Condenser 3. Ambient Temperature Sensor 4. Compressor 5. Discharge Hos ...

Refrigerant line Repair procedures

Replacement 1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose. ...

Other information:

Kia Cee'd JD Service Manual: Neutral Switch Description and operation
Description • Signal of neutral switch is transmitted to the ECM in the neutral state. • This signal is blocked when gear changed. • When the signal is blocked, The ECM controls the fuel injection ...

Kia Cee'd JD Service Manual: Heater & A/C Control Unit (DATC) Repair procedures
Self Diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code After the display the panel blinks three times every 0.5 second, the corresponding fault code blinks on the setup temperature display pan ...