
■ Gasoline engine

■ Diesel engine
1. Be sure the vehicle is on level ground.
2. Start the engine and allow it to reach normal operating temperature.
3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil to return to the oil pan.
4. Pull the dipstick out, wipe it clean, and re-insert it fully.
WARNING - Radiator hose
Be very careful not to touch the radiator hose when checking or adding the engine oil as it may be hot enough to burn you.
5. Pull the dipstick out again and check the level. The level should be between F and L.
CAUTION
CAUTION - Diesel engine
Overfilling the engine oil may cause severe dieseling due to churning effect. It may lead to engine damage accompanied with abrupt engine speed increment, combustion noise and white smoke emission.

■ Gasoline engine

■ Diesel engine
If it is near or at L, add enough oil to bring the level to F. Do not overfill.
Use a funnel to help prevent oil from being spilled on engine components.
Use only the specified engine oil. (Refer to “Recommended lubricants and capacities” in chapter 8.)
Engine oil
Changing the engine oil and filterKia Cee'd JD Owners Manual: 4. Steering wheel control
The above message will appear if the
shift lever is in D (Drive) or R (Reverse)
according to the distance of the front
and rear object from the sensor.
The steering wheel will be controlled
automatically.
The system will be cancelled if you
firmly hold the steering wheel ...
Ford Escape 2020-2025 Owners Manual: Checking the Wiper Blades. Replacing the Front Wiper Blades. Replacing the
Rear Wiper Blades
Checking the Wiper Blades
Run the tip of your fingers over the edge of
the blade to check for roughness.
Replacing the Front Wiper Blades
Lift the wiper arm and then press the
wiper blade locking buttons together.Note: Do not hold the wiper blade to
lift the
wiper arm.
Note: Make sure th ...