Kia Cee'd: SRSCM / PAB ON/OFF Switch Repair procedures

Kia Cee'd JD Service Manual / Restraint / SRSCM / PAB ON/OFF Switch Repair procedures

Removal

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Remove the crash pad side cover. (Refer to Body - "Crash pad side cover")

4.	Disconnect the PAB ON/OFF switch connector (A).

5.	Remove the PAB ON/OFF switch.

Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

3.	Install the PAB ON/OFF switch to the crash pad side cover.

4.	Connect the PAB ON/OFF switch connector.

5.	Install the crash pad side cover. (Refer to Body - "Crash pad side cover")

After installing the SRSCM, confirm proper system operation:

•	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

PAB ON/OFF Switch Components and components location

Components ...

Airbag Module

...

Other information:

Kia Cee'd JD Service Manual: Smart Key Unit Components and components location
Component Connector Pin Information No. Connector A(26 pins) No. Connector B(16 pins) No. Connector C(22 pins) 1 Battery power load 1 CAN H ...

Kia Cee'd JD Owners Manual: Mechanical key
If the transmitter or smart key does not operate normally, you can lock or unlock the doors by the mechanical key. Insert the key into the key hole of the outside door handle.Turn the key toward the rear of the vehicle to unlock and toward the front of the vehicle to lock. I ...