Kia Cee'd: Dual Clutch Transmission Control System / Input Speed Sensor 1 Repair procedures

Kia Cee'd JD Service Manual / Dual Clutch Transmission(DCT) System / Dual Clutch Transmission Control System / Input Speed Sensor 1 Repair procedures

Inspection

Refer to DTC code "P2765, P2766" Input Shaft Speed Sensor.

Removal

1.	Turn off the ignition switch and then disconnect the battery (-) cable.

2.	Remove the under cover.

3.	Disconnect the input shaft speed sensor connector (A).

4.	Loosen the mounting bolt and then remove the input shaft speed sensor (B).

Installation

Install in the reverse order of removal.

Tightening torque :

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Input Speed Sensor 1 Schematic diagrams

Schematic Diagrams ...

Input Speed Sensor 2 Description and operation

Description The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM). It provides i ...

Other information:

Kia Cee'd JD Owners Manual: Starting the gasoline engine
1.Carry the smart key or leave it inside the vehicle. 2.Make sure the parking brake is firmly applied. 3.Manual Transaxle - Depress the clutch pedal fully and shift the transaxle into Neutral. Keep the clutch pedal and brake pedal depressed while starting the engine. Automatic transax ...

Kia Cee'd JD Service Manual: Power Window Motor Repair procedures
Inspection Front Power Window Motor Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Disconnect the connector from the motor. 3. Connect the m ...