Kia Cee'd: Front Seat / Front Seat Cushion Cover Repair procedures

Kia Cee'd JD Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Cushion Cover Repair procedures

Replacement

•	Put on gloves to protect your hands.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the front seat shield inner cover. (Refer to Front Seat - "Front Seat Shield Inner Cover")

2.	Remove the front seat shield outer cover. (Refer to Front Seat - "Front Seat Shield Outer Cover")

3.	Remove the front seat lower protector (A).

4.	Disconnect the front seat heater connectors (A).

5.	Push the protecter (A), and then front seat cushion cover (C) from the front seat frame (B).

6.	Remove the front seat cushion cover (A) from the front seat frame.

7.	After removing the hog-ring clips (A) on the rear of seat cushion and remove the front seat cushion cover (B).

Install in the reverse order of removal.

•	To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).

•	Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].

Front Seat Cushion Cover Components and components location

Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly Components and components location

Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

Other information:

Kia Cee'd JD Service Manual: Wheel Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tig ...

Kia Cee'd JD Service Manual: Inhibitor Switch Repair procedures
Inspection 1. Inspect for loosened connectors, faulty connections, bends, corrosion, contamination, deformation, or damage. 2. Disconnect the inhibitor switch connector. 3. Check the voltage on the p ...