Kia Cee'd: Troubleshooting / A/C Pressure Transducer Repair procedures

Kia Cee'd JD Service Manual / Heating,Ventilation, Air Conditioning / Troubleshooting / A/C Pressure Transducer Repair procedures

Inspection

1.	Measure the pressure of high pressure line by measuring voltage output between terminal “1” and “2”.

Inspect the voltage value whether it is sufficient to be regular value or not.

Vout = 0.00878835 * P + 0.37081095

3.	If the measured voltage value is not within the specification, replace the A/C pressure transducer.

Replacement

1.	Disconnect the negative (-) battery terminal.

2.	Recover the refrigerant with a recovery/charging station.

3.	Disconnect the A/C pressure transducer connector (A).

Remove the A/C pressure transducer (A).

Tightening torque:

10.0 ~ 12.0 N.m (1.02~ 1.22 kgf.m, 7.4~8.8 lb-ft)

•	Be careful not to bend the liquid & suction pipe.

Install in the reverse order of removal.

•	When installing, replace it with a new O-ring (A).

A/C Pressure Transducer Description and operation

Description The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU cont ...

Evaporator Temperature Sensor Description and operation

Description The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by exc ...

Other information:

: Satellite Radio
What Is Satellite Radio Your factory-installed SiriusXM radio system includes a limited subscription term, which begins on the date of sale or lease of your vehicle. See an authorized dealer for availability. For additional information about extended subscription terms, visit www.SiriusXM.com ...

: Engine Oil
Engine Oil Dipstick Overview Minimum. Maximum. Checking the Engine Oil Level Make sure that your vehicle is on level ground. Check the oil level before starting the engine, or switch the engine off after warming up and wait 10 minutes for the oil to drain into the oil pan. Remove th ...